Mahindra Thar 2020+ Black Tail Light Garnish | Glossy Black | ABS Plastic | No Drilling | Pre-Attached Adhesive Tape | Exact Fit | Set of 2

The Mahindra Thar 2020+ Black Tail Light Garnish is a decorative cover for the Thar's tail lights, finished in glossy black and made from ABS plastic. It fits over the tail light housing and gives the rear of the Thar a sharper, more deliberate look while also protecting the tail lights from scratches and dust. The garnish requires no drilling or screwing, uses pre-attached adhesive tape for fitment, and is an exact fit for the Thar's tail light housing. The set includes 2 pieces. Below is what each feature does and why it matters.

Glossy Black Finish

The garnish has a glossy black finish that frames the Thar's tail light area with a clean, polished edge. The high-gloss surface gives the rear of the vehicle a more intentional, finished look and complements the Thar's bold exterior styling without adding bulk or visual noise.

• Finish: Glossy Black

• Effect: Clean, polished framing around the tail light area

• Complements: Thar's rear exterior and overall styling

ABS Plastic Construction

The garnish is made from ABS plastic with a black-plated surface, which delivers the deep glossy look while keeping the body lightweight, rigid, and resistant to weather and impact. ABS plastic does not corrode and holds up to the dust, rain, and road debris the rear of the Thar is exposed to daily.

• Material: ABS Plastic

• Surface: Black-plated

• Properties: Lightweight, rigid, weather-resistant, impact-resistant

No Drilling or Screwing Required

This garnish is designed to install without any drilling or screwing into the vehicle. No holes are made in the bodywork, and no tools are needed to mount it. The entire installation is handled through the pre-attached adhesive tape.

• Drilling required: None

• Screwing required: None

• Tools needed: None for installation

Adhesive Tape Installation: Exact Fit for the Thar

The garnish comes with adhesive tape pre-attached and is shaped to an exact fit for the Mahindra Thar's tail light housing. The adhesive bonds the garnish directly onto the cleaned and dried tail light surface.

Installation steps:

1. Clean the surface: Clean the tail light area thoroughly and make sure it is completely dry.

2. Apply heat (recommended): Use a hair dryer to gently warm the tail light area before applying the garnish. Heat improves adhesive bonding.

3. Peel and align: Remove the adhesive backing, position the garnish over the tail light to confirm the fit, then press firmly into place.

4. Leave to set: Allow the adhesive to fully cure before exposing the car to water or washing.

Post-installation note: Do not wash the car for 3 to 4 days after fitting to allow the adhesive to fully cure.

• Installation method: Pre-attached adhesive tape

• Heat recommended: Yes, a hair dryer helps adhesion

• Fit type: Exact fit for Thar tail light housing

Set of 2 Pieces

The package includes 2 garnish pieces, one for the left tail light and one for the right, covering both sides with a single purchase.

• Set quantity: 2 pieces

• Coverage: Left tail light and right tail light

Made for Mahindra Thar (2020 Onwards)

This tail light garnish is made for the Mahindra Thar from 2020 onwards (2nd Generation). Please confirm your exact model and variant before purchase.

• Fitment: Mahindra Thar (2020 Onwards)

• Generation: 2nd Generation